Chrysler RAM TRUCK 2500 1994 Service Manual page 480

•
WINDSHIELD WIPER AND WASHER SYSTEMS 8K - 11
HAZARD WARNING
908J-9
(2) Mount multi-function switch to column and
torque retaining screws to 2 N*m (17 in, lbs.).
(3) Install steering column covers. Torque retaining
screws to 2 N*m (17 i n . lbs.).
(4) Install tilt lever (tilt column only).
(5) Install battery cable.
(6) Check all functions of switch for proper opera­
tion.
Fig. 13 Multi-Function Switch
INSTALLATION
(1) Install wiring connector to switch and tighten
connector retaining screw to 2 N*m (17 in. lbs.).
WINDSHIELD W A S H E R S
GENERAL INFORMATION
All models are equipped with electric operated
windshield washer pumps.
The electric pump assembly is mounted directly to
the reservoir. A permanently lubricated, sealed motor
is coupled to a rotor type pump. Fluid, gravity fed
from the reservoir, is forced by the pump through
rubber hoses to the nozzles which direct the streams
to the windshield.
These vehicles are equipped with plastic washer
nozzles. Because they are inserted directly into the
cowl grille, there is no adjustment required.
WINDSHIELD WASHER PUMP REPLACEMENT/LOW
FLUID LEVEL SENSOR
REMOWAL
CLAMPS. ALWAYS W E A R S A F E T Y G L A S S E S WHEN
SERVICING CONSTANT TENSION CLAMPS.
CAUTION: A number or letter is stamped into the
tongue of constant tension clamps (Fig. 2). If re­
placement is necessary, u s e only an original equip­
ment clamp with a matching number or letter.
HOSE CLAMP
TOOL 6 0 9 4
HOSE
CLAMP
WARNING: DO NOT LOOSEN THE RADIATOR
DRAINCOCK WITH THE SYSTEM HOT AND PRES­
SURIZED. SERIOUS BURNS FROM THE COOLANT
CAN OCCUR.
DO NOT WASTE reusable coolant. I f the solution
is clean, drain the coolant into a clean container for
reuse.
WARNING: CONSTANT TENSION HOSE CLAMPS
ARE USED ON COOLING SYSTEM HOSES. WHEN
REMOVING OR INSTALLING THIS TYPE OF CLAMP,
ONLY USE TOOLS DESIGNED FOR SERVICING
THIS CLAMP SUCH AS SPECIAL CLAMP TOOL
(NUMBER 6094) (FIG. 1). SNAP-ON CLAMP TOOL
(NUMBER HPC-20) MAY BE USED FOR LARGER
J9207-36
Fig. 1 Hose Clamp Tool—Typical
(1) Remove upper radiator hose at radiator (Fig. 3)
(2) Pull reservoir up and out of radiator shroud
(Fig.
4).
(3) Pull hose off of pump/level sensor and drain
solvent into a clean container.
(4) Disconnect electrical lead from pump/sensor.
(5) Gently pry pump/sensor away from reservoir
and out of grommet. Care must be taken not to punc­
ture reservoir.