•
POWER DOOR LOCKS
8P - 3
S E R V I C E P R O C E D U R E S
SWITCH REPLACEMENT
(1) Remove 2 screws and door pull cup (Fig. 1).
REMOVE 2 SCREWS
J948S-2
Fig. 1 Door Pull Cup
(2) Remove power window/lock switch by reaching
through door pull cup opening and depressing rear
switch retaining tab (Fig. 2).
SWITCH BEZEL
RETAINING TAB
J948S-3
Fig. 2 Switch Bezel Rear Retaining
Tab
( 3 ) Pull rear of switch up and away from door.
(4) Unplug connectors from switch (Fig. 3).
CONNECTOR
LOCKING
TABS
SWITCH PANEL
FRONT CLIP
J948S-8
Fig. 3 Door Switch
Connectors
(5) Plug connector onto new switch.
(6) Install a new switch by inserting front of
switch into trim panel then pushing down rear of
switch.
LOCK MOTOR AND LATCH ASSEMBLY
REPLACEMENT
(1) Remove switch as described in Switch Replace
ment.
( 2 ) Pull power mirror switch control knob rearward
to remove from switch (Fig. 4 ) i f equipped.
DOOR TRIM
PANEL
SWITCH CONTROL
KNOB
J948T-6
Fig. 4 Power Mirror Switch Control Knob
Removal/
Installation
5).
(3) Remove switch retaining nut from switch (Fig.
SWITCH RETAINING
NUT
DOOR TRIM'
PANEL
POWER MIRROR
SWITCH
J948T-5
Fig. 5 Power Mirror Switch Retaining
Nut
To aid in removal of the trim panel, start at
the bottom of the panel.