•
VEHICLE SPEED CONTROL SYSTEM
8H - 13
Fig. 7 Speed Control Cable Attachment at
Servo
(7) Install battery tray. Tighten all battery tray
mounting hardware to 16 N-m (140 in. lbs.).
(8) Install battery i n vehicle making sure that bat
tery is properly positioned on battery tray.
(9) Install battery heat shield, i f equipped.
(10) Install battery holddown clamp, making sure
that i t is properly positioned on battery. Tighten bolt
to 4 N-m (35 i n . lbs.).
SERVO THROTTLE CABLE ASSEMBLY
R E M O V A L
(1) Remove air cleaner (except V-10 and diesel).
(2) Using finger pressure only, remove speed con
trol cable connector at bell crank by PUSHING con
nector off the bell crank (Fig. 8, 9 or 10). DO NOT
try to pull connector off perpendicular to the bell
crank.
(3) Squeeze tabs on speed control cable and push
out of locking plate.
(4) Remove servo cable from servo as described un
der Servo Unit - Removal.
Fig. 8 Speed Control Cable—V6/V8
Typical