6 - 14
CLUTCH
•
Fig. 8 Clutch
Release
Component
Lubrication
Points
APPLY LIGHT COAT OF
HI-TEMP GREASE T O THESE
SURFACES BEFORE INSTALLATION
J9106-15
Fig. 9 Input Shaft Lubrication
Points
(Typical)
(11) Install release lever and bearing i n clutch
housing. Be sure spring clips that retain fork on
pivot ball and release bearing on fork are properly
installed and (Fig. 10).
(12) Install clutch housing (Figs. 11 and 12). Be
sure housing is properly seated on alignment dowels
before tightening housing bolts.
FORK
J9406-18
Fig. 10 Release
Fork And Bearing
Spring
Clip
Position
(13) Install transmission.
(14) Check fluid level in clutch master cylinder.
ENGINE BLOCK
CLUTCH DISC A N D COVER
J9006-32
Fig. 11 Clutch
Housing
Installation
(NV4500)
CLUTCH HOUSiNi REMOVAL (NV4500)
(1) Raise vehicle and remove transmission and
transfer case i f equipped.
(2) Remove clutch housing bolts and remove hous
ing from engine (Figs. 2 and 11).
(3) Clean housing mounting surface of engine block
with wax and grease remover.