Chrysler RAM TRUCK 2500 1994 Service Manual page 517

8S - 4 POWER WINDOWS
To a i d i n removal o f the trim panel, start at
the bottom of the panel.
(4) Using a device such as a trim stick, pry trim panel
away from door around perimeter and remove trim panel.
(5) Roll door watershield away from bottom of door
to allow access to regulator screws (Fig. 6).
Fig. 6 Window Regulator Mounting Screws
(6) Move glass to allow access to glass channel at­
taching screws Figs. 7 and 8).
Fig. 7 Glass Channel Front Attaching Nut
(7) Slide the glass rearward to remove nuts from
door panel.
(8) Pull glass to full up position and tape to door.
(9) Unplug wiring connector from motor.
(10) Remove 2 window track and 2 regulator
screws (Fig. 6).
(11) Loosen 2 regulator screws (Fig. 6).
(12) Remove window regulator from door (Fig. 9).
INSTALLATION
(1) Place regulator inside door by sliding 2 loose
screws i n slots i n door.
•
J 9 4 8 S - 7
Fig. 9 Window Regulator Removal
(2) Install remaining 4 screws.
(3) Tighten 4 regulator screws to 12 N-m (105 in.
lbs.) torque.
(4) Move glass as far rearward into channel as pos­
sible and pushed down. Tighten 2 window track
screws to 12 N-m (105 in. lbs.) torque.
(5) Attach door glass by sliding 2 nuts into the
slots on the channel (Figs. 7 and 8). Tighten door
glass nuts to 12 N-m (105 in. lbs.) torque.
(6) Connect wire harness connector to regulator.
(7) Using 3M 08044 or 3M 08041 adhesive/sealant,
install plastic water dam sheet.
(8) Install power mirror switch into t r i m panel us­
ing retaining nut (Fig. 5), i f equipped.
(9) Install switch to trim panel.
(10) Place trim panel i n the installation position
and press i n nylon retainers.
(11) Install door pull cup and trim panel attaching
screws.
(12) Install switch panel.