Chrysler RAM TRUCK 2500 1994 Service Manual page 490

•
L E N S
Fig. 2 Roof Clearance Lamps
J948L-4
Fig. 3 Center High Mounted Stop Lamp
CARGO LAMP
The cargo lamp is incorporated into the CHMSL, i f
equipped. Refer to Center High Mounted Stop Lamp
paragraph for proper procedures.
SIDE IDENTIFICATION (ID) LAMPS
The bulbs i n the side I D lamps can not be replaced.
I f a bulb should fail, the entire lamp would require
replacement.
LAMPS 8L - 7
REMOVAL (FIG. 4 |
(1) Using a flat blade screw driver, disengage clips
holding I D lamp to retainer.
(2) Separate I D lamp from retainer.
(3) Disengage wire connector from body wire har­
ness.
(4) Separate lamp from vehicle.
(5) Remove screws holding lamp retainer to rear
fender.
(6) Separate retainer from rear fender.
INSTALLATION
Reverse the preceding operation.
Fig. 4 Side Identification Lamps
REAR IDENTIFICATION (ID) LAMPS
The bulbs i n the side ID lamps can not be replaced.
I f a bulb should fail, the entire lamp would require
replacement.
REMOVAL (FIG
m
Si
(1) Remove screws holding rear ID lamps to cargo
box.
(2) Separate I D lamps from cargo box.
(3) Disengage I D lamp wire connector from body
wire harness.
(4) Separate I D lamp from vehicle.
INSTALLATION
Reverse the preceding operation.
TAIL, STOP, TURN SIGNAL AND BACK-UP
LAMPS—PICKUP
REMOVAL (FIG. 6)
(1) Release tailgate latch and open tailgate.
(2) Remove screws holding tail lamp to cargo box.
(3) Disengage clips holding tail lamp to cargo box.
(4) Separate tail lamp from cargo box.
(5) Disengage tail lamp wire connector from body
wire harness.
(6) Separate tail lamp from vehicle.