P O W E R S E A T C I R C U I T
SCHEMATIC
CIRCUIT BREAKER #2
(30 AMP)
BODY • =
GROUND
BATTERY
J948R-1
• Remove switch, refer to Seat Switch Replacement.
Measure voltage at red wire at switch. Meter should
read battery voltage. I f not, repair open to circuit
breaker.
• Measure resistance at black wire at switch. Meter
should read zero ohms. I f OK, replace switch. I f not,
repair open to ground.
SWITCH TESTING
POWER SEAT SWITCH REPLACEMENT
(1) Remove 2 screws holding switch and bezel to
seat (Fig. 2).
(2) Remove 2 screws holding switch to bezel (Fig.
3).
(3) Pull switch from seat far enough to access con
nector, and unplug.
(4) To install switch, reverse removal procedures.
POWER SEAT MOTOR REPLACEMENT
The seat motors are not serviced separately. Re
place the power seat track assembly i f a motor is
faulty.
(1) Remove 3 bolts attaching seat frame to floor
pan.
(2) Remove 1 nut from stud locating seat frame to
floor pan.
(3) Remove 2 bolts holding power seat to center
seat section (Figs. 4 and 5).
7 ^
J948R-2
Fig. 2 Seat Switch and Bezel
Remowal
(4) Unplug power seat wire harness connector lo
cated under seat.
(5) Remove driver's seat from vehicle.
(6) Remove 4 screws attaching seat track to seat
(Fig. 6).
(7) To install power seat track and seat, reverse
the
removal procedures.
Torque seat mounting
screws to 20 N-m (15 ft. lbs.).