•
IGNITION SYSTEMS
80 - 37
SMALL
SCREWDRIVER
HALO LIGHT
RING
908D-16
Fig. 5 Unseated Key Cylinder
halo light ring), proceed as follows: Rotate the key
counterclockwise to the Lock position and remove
the key.
(d) Remove key cylinder (Fig. 6).
INSTALLATION
(1) Install electrical connectors to switch. Make
sure that the switch locking tabs are fully seated i n
the wiring connectors.
(2) Mount ignition switch to the column (Fig. 7).
Fig. 6 Key Cylinder
Removal
Park-lock dowel pin on ignition switch assembly
must engage with column park-lock slider linkage
(Fig. 8). Verify ignition switch is i n lock position (flag
is parallel with the ignition switch terminals) (Fig.
6). Apply a dab of grease to flag and pin. Position
park-lock link and slider to mid-travel. Position igni
tion switch against lock housing face. Be sure pin is
inserted into park-lock link contour slot. Tighten re
taining screws to 2 N-m (17 in. lbs.) torque.
908D-18
Fig. 7 Ignition Switch View From
Column
(3) Assemble cover to the column (3 screws).
Tighten retaining screws to 2 N-m (17 in. lbs.)
torque.
(4) Tilt column: Install t i l t lever (clockwise).
(5) Install negative battery cable(s).
(6) Install key cylinder.
(a) With key cylinder and ignition i n lock posi
tion, gently insert key cylinder into ignition switch
assembly until i t bottoms.
(b) Insert key. While gently pushing on the key
cylinder (inward) toward the ignition switch, rotate
key clockwise to end of travel.