Chrysler RAM TRUCK 2500 1994 Service Manual page 441

8F - 12 AUDIO SYSTEMS
Fig. 6 Radio Connectors
(2) Remove 5 screws holding right side kick panel/
sill trim. Remove kick panel/sill trim.
(3) Remove antenna mast from antenna body (Fig.
Fig. 7 Antenna Mast Removal and Installation
(4) Remove cap nut using antenna nut wrench
C-4816 (Fig. 8).
ADAPTER PR517 A
Fig. 8 Cap Nut and Adapter
(5) Lower antenna assembly down far enough to
gain access to antenna body (Fig. 9).
Fig. 9 Antenna Mounting
(6) Remove antenna lead and body by pulling an­
tenna cable out of cowl and through opening i n cowl
reinforcement.
INSTALLATION
(1) Route antenna cable between fender and cowl
panel to A pillar area.
(2) Insert antenna body through hole i n fender.
(3) Install adapter making sure tab indexes with
opening i n fender and antenna body.
(4) Install cap nut and tighten securely with tool
C-4816.
(5) Install mast to antenna body.
(6) From inside vehicle pull cable i n far enough to
connect cable.
(7) Install kick panel/sill trim.
(8) Connect negative cable to battery.
DOOR MOUNTED SPEAKERS
REMOVAL
(1) Remove 2 screws and door pull cup (Fig. 10).
(2) Remove power window/lock switch by reaching
through door pull cup opening and depressing rear
switch retaining tab (Fig. 11).
(3) Pull rear of switch up and away from door.
(4) Unplug connectors from switch (Fig. 12).
(5) Pull power mirror switch control knob rearward
to remove from switch (Fig. 13).
(6) Remove switch retaining nut from switch (Fig.
14).