•
WINDSHIELD WIPER AND WASHER SYSTEMS
8K - 9
U N L O C K E D
P O S I T I O N
(4) Release plastic anchor screws (Fig. 7).
LOCKED
P O S I T I O N
J948K-21
Fig. 4 Removing Wiper Arm
(2) Rotate arm until tip of wiper blade is ±22MM
to edge of black out (Fig. 5).
(3) Install arm onto pivot shaft.
(4) Grasp wiper arm with left hand and push lock
toward front of vehicle.
(5) Operate wipers with glass wet.
(6) PARK wipers. I f blades are not i n PARK posi
tion remove arms and reposition on pivots.
BLACK OUT
AREA
TIP OF BLADE ± 2 2 M M FROM EDGE OF BLACK OUT
J948K-22
Fig. 5 Adjusting Wiper Arms
WIPER MOTOR REPLACEMENT
REMOVAL
(1) Disconnect negative cable from battery.
(2) Remove wiper arms.
(3) Remove weatherstrip along front edge of cowl
grille (Fig. 6).
PLASTIC
/
SCREW A N C H O R
J948K-4
Fig. 7 Plastic Anchor
Screws
(5) Lift cowl grille from vehicle.
(6) Remove washer hoses from supply hose at Y fit
ting (Fig. 8). Set cowl grille aside.
J948K-5
Fig. 8 Washer
Hoses
( 7 ) Remove wiper linkage mounting bolts (Fig. 9).
J948K-3
Fig. 6 Cowl Grille
Weatherstrip
Fig. 9 Linkage Mounting
Bolts