Chrysler RAM TRUCK 2500 1994 Service Manual page 486

•
LAMPS 8L - 3
HEADLAMP ADJUSTMENT
A properly aimed low beam headlamp will project
top edge of high intensity pattern on screen from 50
mm (2 in.) above to 50 mm (2 in.) below headlamp
centerline. The side-to-side outboard edge of high i n ­
tensity pattern should be from 50 mm (2 in.) left to
50 mm (2 in.) right of headlamp centerline (Fig. 1).
T h e p r e f e r r e d headlamp a l i g n m e n t is 0 for the
u p / d o w n adjustment a n d 1" d o w n f o r t h e left/
r i g h t adjustment* The high beam pattern should be
correct when the low beams are aligned properly.
To adjust headlamp aim, rotate alignment screws
to achieve the specified high intensity pattern.
CENTER OF
VEHICLE T O
CENTER OF ,
H E A D L A M P
LENS
VEHICLE
CENTERLINE'
LOW B E A M HOT
SPOT AREA
FLOOR T O
CENTER OF
HEADLAMP
LENS
PREFERRED
HOT SPOT
LOCATION
7.62 METERS
(25 FEET)
W—T-
/
FRONT OF
HEADLAMP
938L-61
Fig. 1 Headlamp Alignment Screen—Typical