•
POWER MIRRORS
8T - 1
POWER MIRRORS
C O N T E N T S
page
page
. . 6
TEST PROCEDURES
1
. . 4
AUTOMATIC DAY/NIGHT MIRROR
SERVICE PROCEDURES
GENERAL INFORMATION
Electrically-operated remote control mirrors are
available as an option. The mirrors are controlled by
a single switch assembly located on the door panel
(Fig. 1).
The mirror switch is a toggle-type switch. Rotate
the switch clockwise (Right mirror) or counterclock
wise (Left mirror) for mirror selection, and moved up,
down, right, or left for mirror movement direction.
The motors that operate the mirrors are part of the
mirror assembly and cannot be serviced separately.
Fig. 1 Power Mirror
Switch
T E S T PROCEDURES
MIRROR MOTOR TEST PROCEDURE
(1) Remove power mirror switch from mounting po
sition (refer to Service Procedures - Mirror Switch
Replacement).
(2) Disconnect wiring harness at switch connector.
(3) Connect 2 jumper wires as follows and refer to
the Mirror Test Chart for wire hookups at the switch
connector (harness side, not switch side).
• connect one to a 12-volt source
• connect the other to a good body ground.
I f results shown i n chart are not obtained, check
for broken or shorted circuit, or replace mirror as
sembly as necessary.
MIRROR SWITCH TEST PROCEDURE
(1) Remove power mirror switch from mounting po
sition, refer to Service Procedures.
(2) Disconnect wiring harness at switch connector.
(3) Test for continuity (no resistance) between the
terminals of the switch as shown i n the Mirror
Switch Continuity Chart.
(4) I f results shown i n the chart are not obtained,
replace the switch.