I - 22
POWER BRAKE VACUUM PUMP (DIESEL MODELS)
PUMP ASSEMBLY
LOWER MOUNTING
STEERING
.
PUMP
ENGINE BLOCK
J9119-74
Fig. 4 Oil Pressure
Sender
Location
(8) Remove bottom, inboard nut that attaches
adapter to steering pump (Fig. 6). This nut secures a
small bracket to engine block. Nut and bracket must
be removed before pump assembly can be removed
from block.
ENGINE
BLOCK
VACUUM
PUMP
VACUUM
PUMP
OIL FEED
UNE
J9105-96
Fig. 5 OH Feed Line Connection At Pump
(9) Remove upper bolt that attaches pump assem
bly to engine block (Fig. 7).
(10) Remove pump assembly from vehicle (Fig. 8).
VACUUM PUMP REPLACEMENT
(1) Remove nuts
attaching vacuum pump to
adapter (Fig. 8).
BOTTOM-INBOARD
ADAPTER BRACKET NUT
J9105-97
Fig. 6 Adapter And Pump Mounting
Fastener
Location
J9119-76
Fig. 7 Removing Pump Assembly
Upper
Mounting
Bolt
(2) Remove vacuum pump from adapter (Fig. 9).
Turn pump gear back and forth to disengage pump
shaft from coupling i f necessary.
(3) Inspect adapter O-ring (Fig. 9). Replace O-ring
i f cut or torn.
(4) Lubricate adapter O-ring with engine oil.
(5) Note position of drive slots in coupling. Then
rotate drive gear to align tangs on vacuum pump
shaft with coupling (Fig. 10).