Chrysler RAM TRUCK 2500 1994 Service Manual page 766

(2) Position fan to assure clearance for radiator top
tank and hose.
CAUTION: DO NOT lift the engine by the intake
manifold.
(3) Install engine support/lifting fixture.
(4) Raise vehicle on hoist.
(5) Lift the engine SLIGHTLY and remove the
thru-bolt and nut (Fig. 4).
(€) Remove engine support bracket/cushion bolts
(Fig. 4). Remove the support bracket/cushion and
heat shields.
J9409-52
Fig. 4 Engine Front Mounts
INSTALLATION
(1) With engine raised SLIGHTLY, position the en­
gine support bracket/cushion and heat shields to the
block. Install new bolts and tighten to 81 N-m (60 ft.
lbs.) torque.
(2) Install the thru-bolt into the engine support
bracket/cushion.
(3) Lower engine with support/lifting fixture while
guiding the engine bracket/cushion and thru-bolt into
support cushion brackets (Fig. 5).
(4) Install thru-bolt nuts and tighten the huts to
102 N-m (75 ft. lbs.) torque.
(5) Lower the vehicle.
(6) Remove lifting fixture.
ENGINE REAR MOUNT
REMOVAL
(1) Raise the vehicle on a hoist.
(2) Position a transmission jack i n place.
(3) Remove support cushion stud nuts (Fig. 6).
(4) Raise rear of transmission and engine
SLIGHTLY.
(5) Remove the bolts holding the support cushion
to the transmission support bracket. Remove the sup­
port cushion.
CUSHION
BRACKET
J9409-54
Fig. 5 Positioning Engine Front Mounts
Fig. 6 Engine Rear Support Cushion
(6) I f necessary, remove the bolts holding the
transmission support bracket to the transmission
(Fig. 7).
INSTALLATION
(1) I f removed, position the transmission support
bracket to the transmission. Install new attaching
bolts and tighten to 68 N-m (50 ft. lbs.) torque.