Chrysler RAM TRUCK 2500 1994 Service Manual page 208

•
DISC BRAKES § - 4S
Fig. 14 Supporting 4-Wheel Drive Caliper
Fig. 15 Caliper And Steering Knuckle Slide Surfaces
(2) Lubricate caliper mounting bolts, collars, bush­
ings and bores with Dow 111, or GE 661 silicone
grease as follows:
(a) On 1/2 ton models with 75 mm caliper, apply
silicone grease to mounting pins and collars. Then
fill space between bushings i n caliper as shown
(Fig. 16).
(b) On 3/4 and 1 ton models with 80 or 86 mm
calipers, coat mounting pin and interior of bushing
with silicone grease as shown (Fig. 17).
(3) Install inboard brakeshoe i n caliper. Be sure
spring clip on shoe is properly aligned and seated i n
caliper piston (Fig. 18 and 19).
(4) Install outboard brakeshoe i n caliper. Be sure
spring ends are seated i n dimples i n caliper (Fig. 19).
APPLY SILICONE
GREASE WHERE
INDICATED
BUSHINGS
J9405-32
Fig. 16 Mounting Bolt Lubrication (75mm Caliper)
APPLY SILICONE GREASE M O U N T I N G
WHERE INDICATED BOLT
CALIPER
J9405-33
Fig. 17 Mounting Bolt Lubrication (80 or 86mm
Caliper)
(5) Install caliper over rotor and into steering
knuckle mounting arms. Be sure caliper is seated
flush o n m o u n t i n g a r m surfaces as shown (Fig.
20).
(6) Start caliper mounting bolts by hand to avoid
cross threading. Then tighten mounting bolts to 51
N-m (38 ft.lbs.) torque.
(7) Install wheel and tire assemblies.
(8) Lower vehicle and tighten wheel lug nuts to fol­
lowing torque: