Chrysler RAM TRUCK 2500 1994 Service Manual page 297

7 - 42 COOLING SYSTE1
TYPICAL
HOSE
CLAMP
NUMBER/LETTER
LOCATION J9407-39
Fig. 84 Clamp Number/Letter Location
WARNING: CONSTANT TENSION HOSE CLAMPS
A R E U S E D ON MOST C O O L I N G S Y S T E M H O S E S .
WHEN REMOVING OR INSTALLING, U S E ONLY
T O O L S D E S I G N E D F O R SERVICING THIS T Y P E O F
CLAMP, S U C H A S S P E C I A L C L A M P T O O L (NUMBER
6094) (FIG. 63). SNAP-ON CLAMP T O O L (NUMBER
HPC-20) MAY B E U S E D F O R L A R G E R C L A M P S . A L ­
WAYS W E A R S A F E T Y G L A S S E S WHEN S E R V I C I N G
CONSTANT TENSION C L A M P S .
CAUTION: A number or letter is stamped into the
tongue of constant tension clamps (Fig. 64). If re­
placement is necessary, u s e only an original equip­
ment clamp with a matching number or letter.
(4) Remove hose clamps and hoses from radiator.
(5) A l l engines: Remove coolant reserve/overflow
tank hose from radiator filler neck nipple.
(6) A l l engines except 8.0L V-10: Remove the cool­
ant reserve/overflow tank from the fan shroud (pull
straight up). The tank slips into T-slots on the fan
shroud.
(7) Disconnect electrical connectors at windshield
washer reservoir tank and remove tank. Refer to
Group 8K,' Windshield Wiper and Washer Systems
for procedures.
(8) I f equipped with an automatic transmission (all
engines except diesel), disconnect oil cooler lines
(hoses) at radiator tank. A special tool must be used
to disconnect the lines. Refer to Group 21, Transmis­
sions for procedures.
(9) Diesel Engine Only: Remove the two metal
clips retaining the upper part of fan shroud to the
top of radiator.
(10) Remove the four fan shroud mounting bolts
(Fig. 65). Position shroud rearward over the fan
blades towards engine.
RADIATOR
FAN SHROUD M O U N T I N G BOLTS J9407-37
Fig. 65 Typical Fan Shroud Mounting
(11) A l l Engines Except 8.0L V-10 and Diesel: Re­
move the plastic clips retaining the rubber shields to
the sides of radiator. Position rubber shields to the
side.
(12) Remove the two radiator upper mounting
bolts (Fig. 66).
M O U N T I N G
BOLTS
A L I G N M E N T
DOWELS (2) J9407-38
Fig. 66 Typical Radiator Mounting