[Timers] After Last Protocol Digit; [Timers] Silence Limit For Recording; [Timers] Message Backup/Go Ahead Time; [Timers]: Page/Meet-Me Page Hold Timer - NEC UX5000 Manual

Customize
System Options: [Timer]
After Last Protocol Digit
[Timers]
After a voice mail port receives an entire protocol string from the UX5000, this option determines how long
voice mail will wait between the last digit of the string and the receipt of the hangup string.
Options
● 0-99 seconds
Default
✔ 1 second
Silence Limit for Recording
[Timers]
Use this timer to set the length of the pause (silence) allowed when a caller is leaving a message or a Sub-
scriber or Guest Mailbox user is recording a message. If the silence is longer than this interval, the caller
hears, "Recording has been paused due to silence."
See
●
Options
1-999 seconds
●
Default
✔ 5 seconds
Message Backup/Go Ahead Time
[Timers]
Use this timer to set the backup/go ahead interval. This interval sets how far voice mail backs up when a user
dials B while recording or listening to a message. This interval also sets how far voice mail jumps ahead
when a user dials G while listening to a message.
● See
● See
Options
● 1-60 seconds
Default
✔ 5 seconds
Page/Meet-me Page Hold Timer
[Timers]:
This option is not used.
Flash Timer
[Timers]
Use this timer to set the duration of the voice mail port flash (open loop) that occurs when a dial string or
option contains a Flash (F) command. You should only change this option if the Flash command causes
inadvertent disconnects from the UX5000 or outside line.
Options
● 1-999 in 10 mS increments (1 = 10 mS)
Default
✔ 50 (500 mS)
474 ◆ Chapter 3: Programming
This timer is automatically set during installation. You
should not change this entry from its default setting.
R S E
ECORDING ILENCE LIMINATION
L M (
ISTENING TO ESSAGES PAGE
M R ( 220)
ESSAGE ECORD PAGE
for more.
( 265)
PAGE
.
173)
.
UX Mail Manual