Making Connections - NEC Express5800/B120b-d User Manual

3-4 Setting Up Your Server

MAKING CONNECTIONS

Connect peripheral devices to the CPU blade.
IMPORTANT:
Contact the maintenance engineer in your service representative if
you have any requests on the system configuration including the
connection to the uninterruptible power supply system or auto
power controller and the time schedule operation.
If you are installing the CPU blade in the Blade Enclosure
(SIGMABLADE), follow instructions described in the User's Guide
of the Blade Enclosure.
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury. See pages 1-2
to 1-6 for details.
■
■
Observe the following instructions to use the server safely. Failure to follow
these instructions may cause a fire, personal injury, or property damage. See
pages 1-2 to 1-6 for details.
■
■
■
■
■
■
Do not hold the power plug with a wet hand.
Do not connect earth lines to any gas tubes.
Do not plug the power cord in to an improper power source.
Do not connect the power cord to an outlet that has an illegal number of
connections.
Insert the power plug into the outlet as far as it goes.
Use the authorized power cord only.
Do not connect or disconnect any interface cable with the power cord of the
server plugged to a power source.
Do not use any unauthorized interface cable.
WARNING
CAUTION