Mounting The Svp Server To Wall; Connecting Svp Server To Lan; Connecting Power - NEC SVP SERVER - INSTALLATION SETUP AND Installation And Setup Manual

CAUTION
SVP Server Installation, Setup, & Maintenance Manual - Revision 1
Meounting the SVP Server to Wall
The SVP Server can be mounted either horizontally or vertically.
Use the following steps to mount the SVP Server.
Using a 1/8 inch drill bit, drill four pilot holes, on 1.84 by 12.1 inch centers
Step 1
(approximately equivalent to 1-13/16 inch by 12-1/8 inch).
Insert the #8 x 3/4 inch screws in the pilot holes and tighten, leaving a
Step 2
1/8 to 1/4 inch gap from the wall.

Connecting SVP Server to LAN

Using a Cat. 5 cable, connect the NETWORK port on the SVP Server
to the connecting port on the Ethernet switch.

Connecting Power

Use the following steps to connect the power.
Connect the power plug from the AC adapter to the jack labeled PWR on
Step 1
the SVP Server.
Use only the provided Class II AC Adapter with output 24VDC, 1A.
Plug the AC adapter into a 110VAC outlet to apply power to the SVP
Step 2
Server. The system will cycle through diagnostic testing and the LEDs
will blink for about one minute.
Ensure that the system is ready for use:
Step 3
—The ERROR LED should be off.
—Status 1 should be blinking.
After the SVP Server is installed, you must configure the UNIVERGE WL
Mobile Handsets. For Wireless Telephone configuration, see the
Setup and Administration document for the MH110/MH120 Handsets.
Installing the SVP Server 3-3