Table 36: Description Of The Parameters Of The "Administration" Page; 758-874/000-131 Wago-I/O-Ipc-C6 - WAGO -I/O-IPC-C6 Manual

82 Configuration

Table 36: Description of the Parameters of the "Administration" Page

Create bootable image from active partition
Select destination
Configuration of Serial Interface
CoDeSys Debug
I/O-Check
MODBUS RTU
Linux Console
Free Port
(CoDeSys Libs)
File system Check
Select Device
Start Backup System
Start Backup System
Reboot IPC
Press the [Start Reboot] button to restart the I/O-IPC.
Pos: 44.5 /Dokumentation allgemein/Gliederungselemente/---Seitenwechsel--- @ 3\mod_1221108045078_0.doc @ 21810 @ @ 1
Select the media to which you want to copy the image, either from the
CF card to the internal flash memory or to USB storage or vice versa.
Press the [Start Copy] button to copy.
Here, select the service that is to be executed on the serial interface. To
accept your entries, click on the [SUBMIT] button.
Activating "Control Mode" in WAGO-IO-CHECK!
Using WAGO-IO-CHECK, you can overwrite
parameters and process data in "Control Mode"
regardless of whether the fieldbus or PLC
functionalities are enabled or disabled. By doing so,
machine components may be placed in a dangerous
state and personnel and machines may be at risk.
Before changing parameters and process data, ensure
that the machine components are in a safe and defined
state and switch off the higher-level controller. Also
ensure before start-up that no personnel remain in the
danger area of the machine components.
The serial interface is available for some applications such as CoDeSys
(CoDeSys/SysLibCom or SerComLib).
This is how you execute a check of the file system for a device selected
from the list. To start the check, click the [Start Check] button. If
during the check a problem was detected, a corresponding error message
is displayed above on the page about "Configuration of Serial Interface"
("Error while filecheck. If more ..."
Switch the boot loader to start the other system partition the next time
the system is restarted. There is an older version of the firmware here if
you previously restored the system software via the "Firmware Update"
page.
WAGO-I/O-SYSTEM 750

758-874/000-131 WAGO-I/O-IPC-C6

Manual
Version 1.0.0