Table 20: Connections, Contacts And Supply Module Leds; Table 21: Connection For Electronic Supply: Terminal Layout; 758-874/000-131 Wago-I/O-Ipc-C6 - WAGO -I/O-IPC-C6 Manual

WAGO-I/O-SYSTEM 750

758-874/000-131 WAGO-I/O-IPC-C6

Table 20: Connections, contacts and supply module LEDs

Position
60
61
62
63
64
44
Requirements for connecting the power supply:
You have connected two supply lines each to two voltage sources of
•
+24 V DC and 0 V DC in a de-energized state.
You have connected the accompanying socket for the X4 connection to the
•
supply cable.

Table 21: Connection for Electronic Supply: Terminal Layout

X4 connector
3
Pos: 38.4 /Dokumentation allgemein/Gliederungselemente/---Seitenwechsel--- @
Manual
Version 1.0.0
LED/Operating Element
Earth
0 V DC
Field supply, 24 V DC
Power jumper contacts
Data contacts
LED
Pin
1
2 1
2
3
Connecting the Supply Voltage
Color/ Meaning
Status
- Connection of protective earth
- Ground (GND) of the supply voltage
- 24V supply voltage for the sensors/actuators.
The power supply is protected against
reverse polarity.
For the supply of other field potentials; e. g.,
230 V AC, appropriate power supply
modules are available. You can find detailed
information on this in the manuals for the
power supply modules and in the 750-xxx
system description.
- Conduction of the field-side supply voltage
to the connected I/O modules.
- These make the supply voltage (5 V, 1 A)
available for the electronics in the I/O
modules connected to the internal data bus.
The supply voltage is provided by the I/O-
IPC (connection X4).
Green/off The LED lights up if the field supply is
available (see Pos. 62). Otherwise, the LED
is off.
Description
V_IN (+)
GND (-)
Shield (optional)
53
3\mod_1221108045078_0.doc @ 21810 @ @ 1