Port" Page; Modbus" Page; Table 39: Description Of The Parameters Of The "Modbus" Page - WAGO -I/O-IPC-C6 Manual

86 Configuration
9.1.14

"Port" Page

On this page for protocol configuration, select the protocol that you would like to
use for communication. You have a choice between the following protocols:
• Telnet
When using the Linux console through ETHERNET
• CoDeSys Web server
For CoDeSys Web visualization
• FTP
For transferring files
• CoDeSys
For accessing CoDeSys
To accept your entries, click on the [SUBMIT] button.
9.1.15

"MODBUS" Page

On this page, change the MODBUS settings. Choose whether you would like to
use MODBUS/UDP and/or MODBUS/TCP as a protocol for process data
exchange. You also set the MODBUS/TCP timeout on this page. To accept your
entries, click on the [SUBMIT] button.

Table 39: Description of the Parameters of the "MODBUS" Page

MODBUS/UDP
Enabled/Disabled
MODBUS/TCP
Enabled/Disabled
Timeout (msec)
MODBUS/RTU
State
Node ID
Timeout (msec)
Baud rate
Databit
Parity
Stop Bits
Flow Control
758-874/000-131 WAGO-I/O-IPC-C6
Activate or deactivate the MODBUS/UDP protocol here.
Activate or deactivate the MODBUS/TCP protocol here.
Here, set the time period for the MODBUS/TCP connection,
after which the connection is automatically ended during a break
in communication.
Display of the current MODBUS connection that was selected
on the "Administration" page.
Selection of a MODBUS node ID in area 1 – 247.
Here, set the time period for the MODBUS/RTU connection
after which the connection is automatically ended during a break
in communication.
Here, select the transmission speed of the serial interface.
Selection of the databits to be transferred.
Activate/deactivate transmission error recognition.
Here, select the number of stop bits.
Here, set the flow control for hardware and software.
WAGO-I/O-SYSTEM 750
Manual
Version 1.0.0