Hmi Settings" Page; Table 35: Description Of The Screensaver And Cleanmode Parameters On The "Hmi Settings" Page - WAGO -I/O-IPC-C6 Manual

WAGO-I/O-SYSTEM 750
758-874/000-131 WAGO-I/O-IPC-C6
9.1.9

"HMI Settings" Page

On the "HMI Settings" page, change the graphic resolution for the DVI-I
interface, configure the touch screen or monitor, and choose between a English or
German keyboard layout.
To save all settings made on the page, click the [SUBMIT] button. The I/O-IPC
must be restarted or reset to apply the settings.

Table 35: Description of the Screensaver and Cleanmode parameters on the "HMI Settings" page

Screensaver
Display
Screensaver
Wait time (sec)
Manual
Version 1.0.0
Indicates whether the display is switched on or off.
off: red cross and text "off"
on: green check and text "on"
The display can be switched off by the screensaver (after the
corresponding wait time) or explicitly by the user.
The current value is queried and indicated cyclically every two seconds on
the web site (this is only queried once in Configtool instead of cyclically).
The display can be switched on or off using the [Switch on] or [Switch
off] buttons.
These changes are effective immediately.
Indicates the status of the Screensaver Function.
enabled: green check and text "enabled"
disabled: red cross and text "disabled"
When the screensaver is turned on (enabled), the touch screen display is
turned off after the configured wait time and turned on again following
touch screen or keyboard entry.
When the screensaver is turned off (disabled), the display can only be
explicitly switched on or off by the user (see section "Display").
By using the [Enable] or [Disable] buttons, the Screensaver Function can
be immediately activated or deactivated.
This does not effect the current status of the display – even if the
screensaver is activated, the status of the display only changes after
passage of the wait time or pressing on the touch screen/keyboard.
The "Wait time" parameter is only evaluated if the "Screensaver"
parameter has enabled the status. If so, the value indicates the time in
seconds after which the screensaver is activated.
You can change the wait time by changing the value in the input field and
clicking on the [Change] button.
The changes immediately effect the next activation of the screensaver.
Configuration 79