Figure 66: "Bus Parameters" Tab; Table 60: Description Of The Parameters - WAGO -I/O-IPC-C6 Manual

WAGO-I/O-SYSTEM 750
758-874/000-131 WAGO-I/O-IPC-C6
Bus Parameters

Figure 66: "Bus Parameters" tab

The following table explains the parameters listed in the register:

Table 60: Description of the Parameters

Bus Parameters
Baud rate (kBits/s)
Use defaults
Parameters
Slot Time (TSL)
Min. Station Delay (min TSDR)
Max. Station Delay (max. TSDR)
Quiet Time (TQUI)
Setup Time (TSET)
Target Rotation Time (TTR)
Gap Update Factor
Max. Retry Limit
Min. Slave Interval
Poll Timeout
Data Control Time
Manual
Version 1.0.0
PROFIBUS Master in CoDeSys 2.3
Here, set the desired baud rate with which the data is to
be transmitted to the PROFIBUS. The setting is
dependent on your PROFIBUS network (line length, etc.)
If the control field is activated, the settings under
"Parameters" will be automatically taken over from the
GSD file, depending on the baud rate.
Please find the explanation of the PROFIBUS parameters
in the PROFIBUS standard IEC 61158.
141