Safety Advice (Precautions) - WAGO -I/O-IPC-C6 Manual

16 Important Notes
Pos: 23 /Alle Serien (Allgemeine Module)/Überschriften für alle Serien/Wichtige Erläuterungen/Sicherheitshinweise - Überschrift 2 @ 6\mod_1260180299987_21.doc @ 46724 @ 2 @ 1
2.2

Safety Advice (Precautions)

Pos: 24 /Serie 758 (Funk, IPC und PFC)/Wichtige Erläuterungen/Sicherheitshinweise/Sicherheitshinweise 758-87x allgemein 1 @ 10\mod_1312347982980_21.doc @ 75566 @ @ 1
To avoid personal injury, read and observe the following safety information
before using the I/O-IPC and I/O terminals of the 750/753 series.
Electric voltage!
Only operate the I/O-IPC with 24VDC PELV- (Protective Extra Low Voltage) or
SELV (Safety Extra Low Voltage) power sources. There is a danger of electric
shock if this precaution is not observed.
Pos: 25 /Serie 758 (Funk, IPC und PFC)/Wichtige Erläuterungen/Sicherheitshinweise/Sicherheitshinweise 758-87x Heiße Oberseite NUR TEXT @ 10\mod_1314355042561_21.doc @ 77418 @ @ 1
• The I/O-IPC housing may become hot during operation. If the I/O-IPC has
been in operation, allow it to cool off before moving it.
Pos: 26 /Serie 758 (Funk, IPC und PFC)/Wichtige Erläuterungen/Sicherheitshinweise/Sicherheitshinweise 758-87x allgemein 2 @ 10\mod_1314354419585_21.doc @ 77414 @ @ 1
• Observe the appropriate accident prevention regulations for your system
during assembly, start-up, maintenance, and repairs.
• For each activity, observe the corresponding personnel qualification in
Section "Personnel Qualification".
• Read and observe the operating instructions for the WAGO I/O modules
that you connect to the I/O-IPC.
To avoid property damage, read and observe the following information:
• The 750 Series components shall not come in contact with substances
having seeping and insulating properties. Otherwise, additional measures
shall be taken for the devices, such as installation of an enclosure that is
resistant to the above-mentioned substance properties.
• The 750 Series components contain electronic elements that may be
destroyed during electrostatic discharge. When handling these components,
make sure that everything close by is well grounded (persons, work station
and packaging). Do not touch any conducting parts; e.g., data contacts and
printed circuit boards.
• To achieve a high resistance to interference from electromagnetic emissions,
maintain a sufficient distance from electromagnetic sources of interference
(e.g., frequency converters, motors). Use shielded conductors only at the
required sites. Observe the corresponding norms for EMC-compatible
installations as well.
• Replace defective or damaged 750 Series components since malfunctions
may otherwise occur.
• When laying any lines, take care that you do not place them within shear
range of movable system parts.
Pos: 27 /Serie 758 (Funk, IPC und PFC)/Wichtige Erläuterungen/Sicherheitseinrichtungen 758-87x @ 10\mod_1312349440353_21.doc @ 75570 @ 2 @ 1
WAGO-I/O-SYSTEM 750
758-874/000-131 WAGO-I/O-IPC-C6
Manual
Version 1.0.0