Profibus Slaves; Figure 69: "Base Parameters" Tab; Table 62: Description Of The Parameters - WAGO -I/O-IPC-C6 Manual

144 PROFIBUS Master in CoDeSys 2.3
12.2.2

PROFIBUS Slaves

Using the tab described below, you define the behavior of PROFIBUS slaves.
Base Parameters

Figure 69: "Base Parameters" tab

The following table explains the parameters listed in the register that are
automatically assigned by the target system settings (see Section "Designing a
Project and Selecting the Target System"):

Table 62: Description of the Parameters

Base Parameters
Module id
Node id
Input address
Output address
Diagnostic address
Comment:
758-874/000-131 WAGO-I/O-IPC-C6
Recognition of the slave.
Node number of the slave used in the CoDeSys runtime
environment.
Starting address for the input data:
The address space always begins at %IB 4800 and is
automatically assigned. You can also adjust the starting address
manually.
Starting address for the output data:
The address space always begins at %QB 4800 and is
automatically assigned. You can also adjust the starting address
manually.
Memory area for internal diagnostic processing.
Here, you can assign the slave a unique name.
WAGO-I/O-SYSTEM 750
Manual
Version 1.0.0