Diagnostics Of The Fieldbus Coupler; Releasing The Channel Diagnostics; Figure 78: Release Of Channel Diagnostics 1 - WAGO -I/O-IPC-C6 Manual

152 PROFIBUS Master in CoDeSys 2.3
Pos: 46.12 /Serie 758 (Funk, IPC und PFC)/Feldbuskommunikation/CoDeSys-Diagnose 758-87x Einleitung allgemein 1 @ 10\mod_1313131744244_21.doc @ 76545 @ 2 @ 1
12.5

Diagnostics of the fieldbus coupler

This section requires a good knowledge of the CoDeSys programming tool. It
only describes the procedure to create diagnostics using the fieldbus master as an
example.
Configured slaves (e.g., a fieldbus coupler or a fieldbus controller) are a
prerequisite for diagnostics in fieldbus networks.
Pos: 46.13 /Serie 758 (Funk, IPC und PFC)/Feldbuskommunikation/CoDeSys-Diagnose 758-87x DMP Kanaldiagnose freigeben @ 10\mod_1313131671572_21.doc @ 76554 @ 3 @ 1
12.5.1

Releasing the Channel Diagnostics

You can release the diagnostics of the I/O modules to the slave by channel.
Proceed in the following manner:
1. Click on the "Resources" tab and then double click on "PLC Configuration."
2. Click on the name of the slave.

Figure 78: Release of channel diagnostics 1

WAGO-I/O-SYSTEM 750
758-874/000-131 WAGO-I/O-IPC-C6
Manual
Version 1.0.0