WAGO -I/O-IPC-C6 Manual page 163

WAGO-I/O-SYSTEM 750
758-874/000-131 WAGO-I/O-IPC-C6
Station status 2:
Bit 1:
Bit 2:
Bit 3:
Bit 4:
Bit 5:
Bit 6:
Bit 7:
Bit 8:
Station status 3:
Bit 1:
Bit 2:
Bit 3:
Bit 4:
Bit 5:
Bit 6:
Bit 7:
Bit 8:
Master Address:
This byte contains the address of the master that parameterized the slave. If a
slave was not parameterized, then the value is 255.
Ext_Diag_Data:
This is an extended diagnostic buffer. The values are defined in the manual of the
slave station or can be read in the PROFIBUS specification.
Manual
Version 1.0.0
PROFIBUS Master in CoDeSys 2.3
Slave must be parameterized.
Slave provides diagnostic information until
this bit is zero again.
1
Watchdog enabled.
Freeze command enabled.
Sync command enabled.
Reserved
Slave not designed.
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Slave has more diagnostic data than it can
send.
163