Description Of I/O-Ipc Interfaces; Ethernet Interfaces (X8, X9); Figure 6: Rj-45 Geode; Table 12: Act/Lnk And Speed Led - WAGO -I/O-IPC-C6 Manual

WAGO-I/O-SYSTEM 750
758-874/000-131 WAGO-I/O-IPC-C6
Pos: 34.1 /Serie 758 (Funk, IPC und PFC)/Beschreibung der Schnittstellen/Beschreibung der Schnittstellen 758-87x ETHERNET 1 @ 10\mod_1312374986842_21.doc @ 75809 @ 12 @ 1
5

Description of I/O-IPC Interfaces

5.1

ETHERNET Interfaces (X8, X9)

Both ETHERNET interfaces of type RJ-45 are based on the 10/100 BASE-T
transmission standard. These enable, depending on the
data exchange at a transmission rate of 10 Mbit/s or 100 Mbit/s in half-duplex and
full duplex operation respectively.
Pos: 34.2 /Serie 758 (Funk, IPC und PFC)/Beschreibung der Schnittstellen/Beschreibung der Schnittstellen 758-87x - ETHERNET 2 @ 10\mod_1314942425688_21.doc @ 78014 @ @ 1
The "ACT/LNK" and "Speed" LEDs of the two Ethernet interfaces indicate the
current operating status:

Table 12: ACT/LNK and Speed LED

LED
ACT/LNK
Speed
You have the following possibilities for connecting the I/O-IPC to a PC using
Ethernet:
• Directly, with the aid of a crossover cable
• Using a switch or hub in connection with a patch cable
The following table provides information on the Ethernet interface pin
assignments:

Table 13: ETHERNET Interfaces: Pin Assignments

Connector
8
ACT
ACT/LNK
Figure 6: RJ-45
Geode
Pos: 34.3 /Dokumentation allgemein/Gliederungselemente/---Seitenwechsel--- @ 3\mod_1221108045078_0.doc @ 21810 @ @ 1
Manual
Version 1.0.0
Color/Status
yellow
yellow flashing
off
green
Pin
1
2
3
1 4
5
LINK
Speed
6
7
8
Description of I/O-IPC Interfaces
Cause
Connection to a LAN available
Data exchange is taking place.
Transmission speed 10 Mbit/s
Transmission speed 100 Mbit/s
Description
TD+
TD-
RD+
Not assigned
Not assigned
RD-
Not assigned
Not assigned
network used,
ETHERNET
33