Use In Compliance With Underlying Provisions; Technical Condition Of Specified Devices - WAGO -I/O-IPC-C6 Manual

WAGO-I/O-SYSTEM 750
758-874/000-131 WAGO-I/O-IPC-C6
Pos: 19 /Serie 758 (Funk, IPC und PFC)/Wichtige Erläuterungen/Bestimmungsgemäße Verwendung 758-87x 1 @ 10\mod_1312347331946_21.doc @ 75550 @ 3 @ 1
2.1.3

Use in Compliance with Underlying Provisions

The I/O-IPC is used exclusively for controlling automated tasks and Linux
applications. Therefore, it shall not be used for transmitting and processing
security-related information; i.e., for example, emergency stops shall not be
carried out on this equipment.
Pos: 20 /Serie 758 (Funk, IPC und PFC)/Wichtige Erläuterungen/Bestimmungsgemäße Verwendung 758-87x 3 @ 10\mod_1312347595624_21.doc @ 75558 @ @ 1
The I/O-IPC is a class A device and can cause radio interference in residential
areas. If this is the case, you shall only use the I/O-IPC after measures have been
taken to reduce emitted interference.
The I/O-IPC was developed for applications requiring IP20 protection.
The I/O-IPC shall only be used as a unit or in combination with the 750/753
Series I/O Modules.
Up to 64 750/753 series I/O modules may be connected to the I/O-IPC. The use of
up to 250 I/O modules is possible with the WAGO internal data bus extension
(optional). When doing so, the following system parameters shall be observed:
• The total length of the I/O modules behind the I/O-IPC, including the end
module, shall not exceed a maximum of 780mm.
• The maximum size of the process image for the input and output data shall
not exceed 500 bytes in each case.
Applications other than those described in these instructions are not permitted.
Pos: 21 /Alle Serien (Allgemeine Module)/Wichtige Erläuterungen/Technischer Zustand der Geräte - Überschrift 3 und Inhalt @ 3\mod_1221060446109_21.doc @ 21723 @ 3 @ 1
2.1.4

Technical Condition of Specified Devices

The components to be supplied Ex Works, are equipped with hardware and
software configurations, which meet the individual application requirements.
WAGO Kontakttechnik GmbH & Co. KG will be exempted from any liability in
case of changes in hardware or software as well as to non-compliant usage of
components.
Please send your request for modified and new hardware or software
configurations directly to WAGO Kontakttechnik GmbH & Co. KG.
Pos: 22 /Dokumentation allgemein/Gliederungselemente/---Seitenwechsel--- @ 3\mod_1221108045078_0.doc @ 21810 @ @ 1
Manual
Version 1.0.0
Important Notes 15