WAGO-I/O-SYSTEM 750
758-874/000-131 WAGO-I/O-IPC-C6
Pos: 48.11 /Serie 758 (Funk, IPC und PFC)/Betriebssystem/Betriebssystem Linux 758-87x IPC - Zugriff über RS-232 und Terminal, Einleitung + Schritt 1 @ 11\mod_1315393108650_21.doc @ 78782 @ 4 @ 1
14.4.1.2
Access via RS-232 Interface and Terminal Program
In order to access the Linux console via RS-232 interface using a terminal
program, proceed as follows:
1.
In the WBM or IPC configuration tool, assign the Linux console to the
RS-232 interface. For this, see section "Administration".
Pos: 48.12 /Serie 758 (Funk, IPC und PFC)/Betriebssystem/Betriebssystem Linux 758-87x IPC mit Feldbus - Zugriff über RS-232 und Terminal, Schritt 2 @ 10\mod_1313400859077_21.doc @ 76907 @ @ 1
2.
Connect the serial interface of the PC with RS-232 interface X6 (12) of the
I/O-IPC using a null modem cable.
Pos: 48.13 /Serie 758 (Funk, IPC und PFC)/Betriebssystem/Betriebssystem Linux 758-87x IPC mit Feldbus - RS-232-Schnittstelle X6 - Bild @ 10\mod_1312533669046_21.doc @ 75977 @ @ 1
12
Figure 104: RS-232 interface X6
Pos: 48.14 /Serie 758 (Funk, IPC und PFC)/Betriebssystem/Betriebssystem Linux 758-87x IPC - Zugriff über RS-232 und Terminal, Schritte 3 - 7 @ 10\mod_1312533822280_21.doc @ 75985 @ @ 1
3.
Open a terminal program (Linux: e.g. minicom, Windows: e.g. hyper
terminal) on your PC.
4.
Enter the communication parameters of the I/O-IPC serial interface set
beforehand into the terminal program:
•
•
•
•
•
5.
The Linux console start screen appears.
6.
Enter your user name (See section "Access to the Linux console")
7.
Enter the password for your user name. The Linux console of the I/O-IPC
opens in the HOME directory (
Pos: 48.15 /Dokumentation allgemein/Gliederungselemente/---Seitenwechsel--- @ 3\mod_1221108045078_0.doc @ 21810 @ @ 1
Manual
Version 1.0.0
Run
Stop
RST
Speed: 115200 bit/sec
Data width: 8 Bit
Parity: none
Stop bits: 1 Bit
Flow control: none
~
) of the selected user.
Operating System
183