Diagnostics; Operational Messages; Figure 107: Identification Of Leds; Table 71: I/O-Ipc Operational Messages - WAGO -I/O-IPC-C6 Manual

198

Diagnostics

Pos: 50 /Alle Serien (Allgemeine Module)/Überschriften für alle Serien/Diagnose - Service/Diagnose - Überschrift 1 @ 4\mod_1240831069471_21.doc @ 31372 @ 1 @ 1
15 Diagnostics
Pos: 51.1 /Serie 758 (Funk, IPC und PFC)/Diagnose/Diagnose LED-Signalisierung 758-87x allgemein @ 10\mod_1312534609600_21.doc @ 76001 @ 2 @ 1
15.1

Operational Messages

All operational messages of the I/O-IPC are described in the table below. These
messages are indicated by LEDs:
Pos: 51.2 /Serie 758 (Funk, IPC und PFC)/Diagnose/Diagnose LED-Signalisierung 758-87x FB - Bild @ 10\mod_1312535195873_21.doc @ 76008 @ @ 1

Figure 107: Identification of LEDs

Pos: 51.3 /Serie 758 (Funk, IPC und PFC)/Diagnose/Diagnose LED-Signalisierung 758-87x Tabelle allgemein 1 @ 10\mod_1313038907721_21.doc @ 76398 @ @ 1

Table 71: I/O-IPC Operational Messages

Position
30/32
31/33
35
36
31
30 32 33
Run
Stop
RST
LED Color/Status
ACT/LNK OFF
Yellow
Yellow flashing
Speed Green
OFF
U2 Green, red,
yellow, off,
U1 Green, red,
yellow, off
WAGO-I/O-SYSTEM 750
758-874/000-131 WAGO-I/O-IPC-C6
40 41
38 39
37
36
35
Cause
I/O-IPC has no
connection to the
ETHERNET network
Connection to the
ETHERNET network is
available.
Data is being
exchanged over
ETHERNET network.
Transmission speed
100 Mbit/s
Transmission speed
10 Mbit/s
-
-
42
43
44
A A
C
C
B B
D
D
Explanation/Remedy
Check the cables for
ETHERNET interfaces
X8/X9.
-
-
Transmission speed is
defined by the
ETHERNET network
participants.
LED that can be freely
programmed by the user
(using MiscLib.lib).
LED that can be freely
programmed by the user
(using MiscLib.lib).
Manual
Version 1.0.0