Removing The I/O-Ipc From The Mounting Rail; Figure 17: Removing The I/O-Ipc From The Mounting Rail - WAGO -I/O-IPC-C6 Manual

WAGO-I/O-SYSTEM 750
758-874/000-131 WAGO-I/O-IPC-C6
Pos: 36.22 /Serie 758 (Funk, IPC und PFC)/Montieren/Demontage 758-87x allgemein 2 @ 10\mod_1312441023649_21.doc @ 75856 @ 3 @ 1
6.6.2

Removing the I/O-IPC from the Mounting Rail

Remove the I/O-IPC from the mounting rail as described below:
1. First, disconnect from the power supply those parts of the system on which
you have mounted the I/O-IPC.
2. Then, pull the orange release tab (24) to remove the first 750 Series I/O
Module connected to the I/O-IPC from the mounting rail (A and B).
Pos: 36.23 /Serie 758 (Funk, IPC und PFC)/Montieren/Demontage 758-87x 2 Handlung @ 10\mod_1315201214389_21.doc @ 78111 @ @ 1
3. Press the four release levers (23) with both hands at the same time until they
stop and then remove the I/O-IPC from the mounting rail (C).
Pos: 36.24 /Serie 758 (Funk, IPC und PFC)/Montieren/Demontage 758-87x - FB Bild 2 @ 10\mod_1312441093558_21.doc @ 75859 @ @ 1
A
B
C

Figure 17: Removing the I/O-IPC from the mounting rail

Pos: 37 /Dokumentation allgemein/Gliederungselemente/---Seitenwechsel--- @ 3\mod_1221108045078_0.doc @ 21810 @ @ 1
Manual
Version 1.0.0
Installing and Removing the I/O-IPC
23
23
24
...
24
...
...
49