Table of Contents
Advertisement
CHAPTER 5 TROUBLESHOOTING
6) Press SW976 on the switch PCB.
•
The setting will be stored, and the front/
rear aligning plate return to home posi-
tion.
•
If you happen to have pressed SW975
too many times and the front aligning
plate has moved too far, press SW974.
The front aligning plate will stop once,
returns to home position, and then
moves back to adjustment start position.
Go back to step 5), and start over.
7) Turn off the power.
8) Shift all bits of SW973 of the finisher
PCB to OFF.
9) Turn on the power.
•
The swing guide will move down.
5-2
COPYRIGHT© 2001 CANON INC.
1.1.2 Adjusting the Stapling Position
(front, 1-position)
If you have replaced the EEPROM of the
finisher controller PCB or the stapler, make
the following adjustments:
1) Using the door switch actuator, turn on
the two door switches. Set SW973 of
the switch PCB as indicated:
AB-configuration
ON
Inch-configuration
ON
2) Press SW976 on h switch PCB.
•
The swing guide of the finisher opens
and, at the same time, the front aligning
plate and the rear aligning plate return
to home position. Then, the front align-
ing plate and the rear aligning plate
move to the front 1-point stapling posi-
tion. The stapler also moves to the front
1-point stapling position. DSP771 on
the switch PCB indicates the latest set-
ting, which is between '-12' and '12'.
3) Keep several sheets of A4 or LTR paper
together, and insert the stack into the
handling tray. At this time, be sure to
butt the trailing edge of the stack
against the rear aligning plate.
2000 2000 2000 2000
CANON SADDLE FINISHER K3/K4 REV.0 MAR. 2001
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
F05-101-03
Advertisement
Table of Contents
Troubleshooting
