0X6049/N Velocity Deceleration - BONFIGLIOLI Vectron ACTIVE CUBE Series Manual

12.5.10 0x6049/n Velocity deceleration

Index Sub-index
0x6049 0
1
2
Object works in:
• Motion Control:
Velocity mode
o
Non motion Control (conf. ≠ x40)
•
The deceleration in velocity mode is set with object
velocity deceleration
The gradient of the frequency in the deceleration period is written to parameters
celeration (clockwise)
sets in RAM only !). Both parameters are set to the same value.
The values of p.421 and p.423 are converted internally to a frequency/sec value, taking
into account the parameter
The gradient is changed internally by altering the objects delta time or delta speed.
No.
0x6049/1 Delta speed (RPM)
0x6049/2 Delta time (sec)
If objects 0x6049/1 or 0x6049/2 were written and then a save parameters command
(object 0x1010) processed, the object values are stored in non-volatile memory. After
the next power on of the inverter, the previously set values are reactivated and over-
write the settings of parameters
terclockwise
78
Meaning
Highest sub-index supported
-1
Delta speed (min )
Delta time (sec)
delta speed
consists of
421 and
Deceleration (anti-clockwise)
No. of Pole Pairs
Parameter
Object
speed
delta speed
Deceleration Clockwise
423.
CM-EtherCAT
Data type
Unsigned8
Unsigned32
Unsigned16
Object doesn't work in:
• Motion Control:
Table Travel record mode
o
Profile Positioning mode
o
Profile Velocity mode
o
Homing mode
o
Interpolated mode
o
Cyclic Sync Position mode
o
Cyclic Sync Velocity mode
o
Move away from Limit Switch
o
Electronic Gear: Slave
o
velocity deceleration
delta time
in rpm and
373 (in data set 1 !).
Min.
1
1
delta time
421 und
Access Map Def.-Val
ro No 2
rw No 0x96
rw No 1
. The object
in seconds.
423 (data set 5, all data
Setting
Max.
32767
(= 0x7FFF)
65535
(= 0xFFFF)
time
Deceleration Coun-
07/13
De-