BONFIGLIOLI Vectron ACTIVE CUBE Series Manual page 20

In this document, the hardware circuitry, relevant parameters and the available ob-
jects are described.
The available objects are divided by:
The functions and objects are described in this manual to the extent necessary. For
more information, refer to the standards of EtherCAT Technology Group (ETG).
The standards referred to are available at:
20
Communication objects
Manufacturer objects
Standardized objects
EtherCAT Technology Group
Headquarters
Ostendstr. 196
90482 Nürnberg, Germany
E-Mail: info@ethercat.org
Web: www.ethercat.org
NOTE
With the CM-EtherCAT communication module, it is possible to access
ALL frequency inverters parameters from a controller. There is no ac-
cess control via the control level as in the case of the KP500 manual
control unit or the VPlus PC software. Changing parameters, the func-
tions of which are not known to the user, can result in unintended
movements and material and/or personal losses as well as inoperative-
ness of the frequency inverter.
NOTE
If values are to be written cyclically, follow the notes in Chapter 12.3.1
"Handling of data sets/cyclic writing of the parameters".
For operation with a controller, a XML is required. You will find this XML
file in the documentation of the product CD.
Hexadecimal values are marked in the following by a preceding "0x".
CM-EtherCAT
(0x1nnn)
(0x2nnn)
(0x6nnn)
Phone: +49 (911) 5 40 56 - 20
Fax: +49 (911) 5 40 56 - 29
07/13