Table of Contents
Advertisement
15) Apply water tight sealant where brake back plate (1) and
parking brake cable contact.
Connect parking brake cable (2) to brake back plate (right &
left) and secure it with clip (3).
"A": Sealant 99000-31090
NOTE:
Check to ensure that clip is in good condition before
installing it. If deformed or broken, replace.
16) Install parking brake cable clamps to trailing arm.
17) Install wheel speed sensors (right & left) and clamp wire
securely (if equipped with ABS).
18) Install brake shoes (right & left) referring to "Brake Shoe
Removal and Installation" in Section 5C.
19) Install brake drums (1) (right & left) after making sure that
inside of brake drum and brake shoes are free from dirt and
oil. Then tighten brake drum screw (2).
20) Fill reservoir with brake fluid and bleed brake system. (For
bleeding operation, refer to "Air Bleeding of Brake System" in
Section 5.)
21) Refill differential gear housing with new specified gear oil.
Refer to "Rear Differential Gear Oil Change" in Section 7F.
22) Install wheels and tighten wheel bolts to specified torque.
Tightening torque
Wheel bolt (f): 95 N·m (9.5 kg-m, 69.0 lb-ft)
23) Upon completion of all jobs, pull parking brake lever with
about 200 N (20 kg, 44 lbs) load three to five times so as to
obtain proper drum-to-shoe clearance.
Adjust parking brake cable referring to "Parking Brake
Inspection and Adjustment" in Section 5.
24) Lower hoist.
REAR SUSPENSION 3E-33
Advertisement
Table of Contents
