Table of Contents
Advertisement
5B-8 FRONT BRAKE
4) Tighten wheel bolts to specification.
Tightening torque
Wheel bolt (c): 95 N·m (9.5 kg-m, 69.0 lb-ft)
5) After completing installation, fill reservoir with brake fluid and
bleed brake system. Perform brake test and check each
installed part for oil leakage.
Front Disc Brake Caliper Boot Inspection
Check boot for breakage, crack, damage and leakage. If defec-
tive, replace piston seal and piston boot.
Front Disc Brake Caliper Disassembly and
Assembly
DISASSEMBLY
WARNING:
Do not apply too much highly compressed air which will
cause piston to jump out of cylinder. It should be taken
out gradually with moderately compressed air. Do not
place your fingers in front of piston when using com-
pressed air.
Before disassembly, clean all around caliper with brake fluid.
1) Blow compressed air into cylinder through bolt hole where
flexible hose was fitted.
With this air pressure, piston can be pushed out of cylinder.
Advertisement
Table of Contents
