Table of Contents
Advertisement
2
1
4
3
"A"
"A"
Installation
1) Install belt (1) to water pump pulley (2), crankshaft pulley (3)
and generator pulley (4).
2) Adjust belt tension by referring to "Water Pump/Generator
Drive Belt Tension Inspection and Adjustment" in this sec-
tion.
5
3) If vehicle equipped with A/C, install compressor drive belt (5)
referring to "Compressor Drive Belt Inspection and Adjust-
ment" in Section 1B.
4) Connect negative cable at battery.
Water Pump Removal and Installation
Removal
1) Disconnect negative cable at battery.
2) Drain coolant referring to "Cooling System Draining" in this
section.
3) Remove water pump/generator drive belt referring to Water
Pump/Generator Drive Belt Removal and Installation" in this
section.
4) Remove water pump assembly (1).
Installation
1) Apply sealant to mating surface of water pump (1) as shown
in figure.
1
"A" : Sealant 99000-31150
Sealant quantity (to mating surface of water pump)
"a"
Width "a" : 3 mm (0.12 in.)
Height "b" : 2 mm (0.08 in.)
"b"
ENGINE COOLING 6B-15
Advertisement
Table of Contents
