Table of Contents
Advertisement
"EPS" Warning Lamp Does Not Come ON at Ignition Switch ON But Leaving
Engine OFF
WIRING DIAGRAM
5
1
G22-11
1. Main fuse box
2. Circuit fuse box
3. "P/S" fuse (30 A)
4. "METER" fuse (10 A)
TROUBLESHOOTING
Step
1
1) Turn ignition switch ON.
Do the other warning lamps come on?
2
1) Ignition switch OFF.
2) Remove and inspect the "P/S" fuse.
Is fuse in good condition?
3
1) With ignition switch OFF, disconnect P/S
control module connector ("G13").
2) Check for proper connection to the P/S con-
trol module at "G13-2" terminal.
3) Measure resistance between "G13-2"
("BLK" wire) terminal and body ground.
Is it infinite (∞)?
2
3
WHT/BLU
BLK/RED
4
BLK/YEL
BLU/ORN
BLU/ORN
BLU/ORN
6
7
G22-22
PNK
8
G21-15
PPL
BLK
5. Ignition switch
6. Combination meter
7. "EPS" warning lamp
8. Speedometer
Action
ELECTRICAL POWER STEERING (P/S) SYSTEM 3B1-13
10
G13-1
G13-1
G13-5
G13-8
11
9
G13-5
G21-15
12
G13-7
G13-2
G22-11
9. P/S control module
10. Connector G13 (viewed from terminal side)
11. Connector G21 (viewed from terminal side)
12. Connector G22 (viewed from terminal side)
Yes
Go to Step 2.
Reinstall the "P/S" fuse,
and then go to Step 3.
"BLK" wire circuit open.
G13-2
G13-8
G13-7
G22-22
No
"BLK/YEL", "BLU/ORN"
wire circuit or "METER"
fuse open or short to
ground.
Check "BLK/RED" wire
circuit for short to ground.
If OK, replace the "P/S"
fuse.
Go to Step 4.
Advertisement
Table of Contents
