Table of Contents
Advertisement
3E-8 REAR SUSPENSION
On-vehicle Service
Lateral Rod Removal and Installation
REMOVAL
1) Hoist vehicle.
2) Remove lateral rod nuts (1) and bolt (2).
3) Remove lateral rod (3).
[A]: 2WD model
[B]: 4WD model
INSTALLATION
1) Install lateral rod (1) or (2) to rear axle (or axle housing) (3)
and vehicle body (4) referring to figure for proper installing
direction of bolt (5) and washer (6).
Tighten nuts (7) temporarily at this step.
NOTE:
• When installing Rod (1) for 2WD, identify rod end by
smaller diameter "a" and install that end to vehicle
body side.
• When installing rod (2) for 4WD, identify rod end by
damper (8) and install that end to vehicle body side.
Also make sure that both dampers are directed rear-
ward of vehicle.
[A]: 2WD model
[B]: 4WD model
2) Lower hoist.
Advertisement
Table of Contents
