Table of Contents
Advertisement
4) Remove E-rings (2) (right & left) securing brake hose (1).
5) Disconnect brake pipe flare nuts (1) from wheel cylinders (3)
(right & left) and put bleeder plug cap (4) onto pipe (2) to pre-
vent fluid from spilling.
CAUTION:
Do not allow brake fluid to get on painted surfaces.
6) Remove brake back plates (1) (right & left) from rear axle
and hang removed brake back plate with a wire hook.
7) Remove lateral rod axle side nut (1).
REAR SUSPENSION 3E-17
Advertisement
Table of Contents
