Suzuki Ignis Service Manual page 3142

e) Pull brake drum (1) off by hand.
If it is hard to remove, use special tools.
Special tool
(A): 09942-15111
(B): 09943-17912
NOTE:
When drum is removed, visually inspect wheel cylinder
for brake fluid leakage. Correct leaky point if any.
INSTALLATION
1) Before installing brake drum, check outer diameter "a" of
brake shoes. If it is not within value as specified below,
adjust it to specification by turning adjuster.
Brake shoes Measured brake
outer diameter = drum inside
"a" diameter
2) Install brake drum after making sure that inside of brake
drum and brake shoes are free from dirt and oil.
3) Install new spindle nut (1).
4) Tighten spindle nut (1) to specified torque.
Tightening torque
Spindle nut (a): 175 N·m (17.5 kg-m, 126.5 lb-ft)
5) Calk spindle nut (1).
6) Install spindle cap.
NOTE:
• When installing spindle cap, hammer lightly several
locations on the collar of cap until collar comes closely
into contact with brake drum.
• If fitting part of cap is deformed or damaged or if it is
fitted loosely, replace with new one.
7) Upon completion of all jobs, depress brake pedal with about
300 N (30 kg, 66 lbs) load at least 15 – 20 times until
adjuster actuator clicking sound from drum brake can not be
heard so as to obtain proper drum-to-shoe clearance.
Adjust parking brake cable. For adjustment, refer to "Parking
Brake Inspection and Adjustment" in Section 5.
8) Install console box cap if removed.
PARKING AND REAR BRAKE 5C-5
0.5 to 1.0 mm
–
(0.02 to 0.04 in.)