Table of Contents
Advertisement
1
1
2
MANUAL TRANSAXLE (Z13DT ENGINE MODEL) 7A3-11
Dismounting
1) Disconnect negative cable at battery.
2) Remove battery tray with coolant reservoir.
3) Remove air cleaner and resonator.
4) Remove water pipe bracket and water hoses.
5) Disconnect clutch cable from clutch release shaft and
bracket.
6) Disconnect shift and select cables from transaxle and then
remove its bracket on transaxle.
7) Undo reverse lamp connector.
8) Support engine using engine hanger.
9) Remove transaxle to engine bolts (1). (upper side)
10) Drain transaxle oil referring to "Manual Transaxle Oil
Change" in this section.
11) Remove front drive shafts referring to "Front Drive Shaft
Assembly Removal and Installation" in Section 4A.
12) Remove exhaust pipe.
13) Remove lower member. (For RM413D)
14) Remove ground cable from transaxle.
15) Remove transaxle to engine bracket.
16) Support transaxle with transmission jack.
17) Remove engine left mounting with bracket (1).
18) Remove engine rear mounting with bracket (2).
19) Remove transaxle to engine bolts. (lower side)
20) Pull transaxle out so as to disconnect cluster gear from
clutch disc and then lower it.
Advertisement
Table of Contents
