Table of Contents
Advertisement
5A-30 BRAKES PIPE / HOSE / MASTER CYLINDER
1
"b"
2
1
"b"
2
"a"
3
"b"
"a"
"b"
Brake Pedal and Brake Pedal Bracket
Removal and installation
REMOVAL
1) Disconnect stop light switch coupler.
2) Disconnect push rod clevis from brake pedal.
3) Remove attaching nuts.
4) Remove brake pedal bracket with brake pedal.
5) Remove each parts, if necessary.
INSTALLATION
Reverse removal procedure for installation, noting the following.
• Tighten each nuts and screws to specified torque as indi-
cated above figure.
Tightening torque
Brake pedal mounting nut: 23 N·m (2.3 kg-m, 17.0 lb-ft)
• After installing, check brake pedal play and perform brake
test.
Stop (Brake) Lamp Switch Removal and
Installation
REMOVAL
1) Disconnect stop lamp switch coupler.
2) Pull out switch slider (1) of stop lamp switch in the direction
of arrow "a" in the illustration.
Then, pull out adjuster (2) in the direction of arrow "b" in the
illustration.
3) Remove stop lamp switch with pressing its pin (3) to inside.
INSTALLATION
1) Pull out switch slider (1) of stop lamp switch in the direction
of arrow "a" in the illustration.
Then, pull out adjuster (2) in the direction of arrow "b" in the
illustration.
2) Install stop lamp switch.
3) Adjustment of stop lamp switch is un necessary.
When brake pedal is depressed, adjuster adjust the suitable
distance automatically.
Advertisement
Table of Contents
