Table of Contents
Advertisement
6A3-28 ENGINE MECHANICAL (Z13DT ENGINE)
1
4
6
8
9
2
10) Disconnect the following electric lead wires.
5
3
11) Remove right and left side engine under covers.
12) Remove water pump and generator drive belt referring to
7
13) With hose connected, detach A/C compressor from its
14) Drain engine oil referring to "Engine Oil and Oil Filter
15) Drain transaxle oil referring to "Manual Transaxle Oil
16) For RM413D, remove cross member (1).
17) Remove exhaust No.1 pipe referring to "Exhaust Pipe
18) Remove stabilizer bar referring to "Stabilizer Bar and Bush-
19) Disconnect right and left drive shaft joints from differential
1
20) Support engine with lifting device.
9) Disconnect the following hoses.
• Brake booster hose (1)
• Fuel return hose (2)
• Fuel feed hose (3)
• Radiator inlet (4) and outlet hoses
• Heater inlet and outlet hoses
• Reservoir hoses (for RM413D)
• ECM (5)
• Injector harness to instrument panel harness (6)
• Injector harness to main harness
• Back up light switch
• Magnet clutch switch of A/C compressor (if equipped)
• Generator (7)
• Starting motor (8)
• Engine oil level sensor
• Engine ground (9)
• Each wire harness clamps
"Water Pump / Generator Drive Belt Removal and Installa-
tion" in Section 6B3.
bracket. (if equipped)
NOTE:
Suspend removed A/C compressor at a place where no
damage will be caused during removal and installation of
engine assembly.
Replacement" in Section 0B.
Change" in Section 7A3.
Removal and Installation" in Section 6K3.
ings Removal and Installation" for RM413D or "Stabilizer Bar
and Bushings" for RB413D in Section 3D.
gear referring to "Front Drive Shaft Assembly Removal and
Installation" in Section 4A for RM413D or "Front Drive Shaft
Assembly Removal and Installation" in Section 4A2 for
RB413D.
NOTE:
For engine and transaxle removal, it is not necessary to
remove drive shafts from steering knuckle.
Advertisement
Table of Contents
