Suzuki Ignis Service Manual page 2603

6A3-62 ENGINE MECHANICAL (Z13DT ENGINE)
Pistons, Piston Rings, Connecting Rods and Cylinder Components
CAUTION:
• Connecting rod and connecting rod bearing cap must be replaced as a set when either replacement
becomes necessary.
• Note original position in which each piston, piston ring, connecting rod and connecting rod bearing
cap were installed, and install them to original position.
If each piston, piston ring, connecting rod and connecting rod bearing cap is not installed to origi-
nal position, engine will spoil its original performance.
5
6
1. Top ring
2. 2nd ring
3. Oil ring
4. Piston
5. Piston pin
1
2
3
4
6. Piston pin circlip
7. Connecting rod
8. Connecting rod bearing
9. Connecting rod bearing cap
10. Connecting rod bearing cap bolt
: Tighten 20 N·m (20 kg-m, 14.5 lb-ft) and 40° by the specified.
Pistons, Piston Rings, Connecting Rods and
Cylinder Removal and Installation
CAUTION:
• Connecting rod and connecting rod bearing cap must
• Note original position in which each piston, piston
7
6
9
be replaced as a set when either replacement becomes
necessary.
ring, connecting rod and connecting rod bearing cap
were installed, and install them to original position.
If each piston, piston ring, connecting rod and con-
necting rod bearing cap is not installed to original
position, engine will spoil its original performance.
8
10
Tightening Torque
Apply engine oil to sliding surface
Do not reuse.