Table of Contents
Advertisement
19) Install CKP sensor referring to "Crankshaft position (CKP)
sensor (engine speed sensor) removal and installation" in
Section 6E3.
20) Install cylinder head assembly referring to "Valves and Cylin-
der Head Assembly Removal and Installation" in this section.
21) Install engine assembly to engine compartment referring to
"Engine Assembly Removal and Installation" in this section.
Main Bearings, Crankshaft and Cylinder
Block Inspection
Crankshaft Thrust Play
1) Install main bearing, main bearing (with thrust bearing),
crankshaft and lower crankcase referring to "Main Bearings,
Crankshaft and Cylinder Block Removal and Installation" in
this section.
2) Using a dial gauge, measure displacement in axial (thrust)
direction of crankshaft.
If measured value is out of specification, replace main bear-
ing (with thrust bearing).
Crankshaft thrust play
0.055 – 0.265 mm (0.00217 – 0.01043 in.)
Main Bearing
General information
• Upper half of bearing (1) has oil groove (2) as shown in fig-
ure.
1
Install this half with oil groove to cylinder block.
• Lower half of bearing does not have oil groove.
2
Visual inspection
Check bearings for pitting, scratches, wear or damage.
If any malcondition is found, replace both upper and lower halves.
Never replace either half without replacing the other half.
ENGINE MECHANICAL (Z13DT ENGINE) 6A3-77
Advertisement
Table of Contents
