Suzuki Ignis Service Manual page 2938

1
(A)
1
(A)
ELECTRICAL POWER STEERING (P/S) SYSTEM 3B1-7
"EPS" Warning Lamp Check
1) Turn ignition switch to ON position (but without running
engine) and check if the "EPS" warning lamp lights up. If the
lamp dose not light up, go to ""EPS" Warning Lamp Dose
Not Come ON at Ignition Switch ON But Leaving Engine
OFF" of the diagnostic flows.
2) Start engine and check if the "EPS" warning lamp turns OFF.
If the lamp comes OFF, the P/S system is in good condition.
DTC Check
1) Turn ignition switch to OFF position.
2) Connect Suzuki Scan Tool to data link connector (DLC) (1)
located on underside of instrument panel at driver's seat
side.
Special tool
(A): Suzuki Scan Tool
3) Turn ignition switch to ON position.
4) Read DTC according to the instructions displayed on Suzuki
Scan Tool. For further details, refer to operator's manual for
Suzuki Scan Tool.
NOTE:
If communication between Suzuki Scan Tool and the
vehicle can not be established, perform "Serial Data Link
Circuit Check" described in this section.
5) After completing the check, turn ignition switch to OFF posi-
tion and disconnect Suzuki Scan Tool from DLC.
DTC Clearance
1) Turn ignition switch to OFF position.
2) Connect Suzuki Scan Tool to data link connector (DLC) (1)
located on underside of instrument panel at driver's seat
side.
Special tool
(A): Suzuki Scan Tool
3) Turn ignition switch to ON position.
4) Erase DTC according to the instructions displayed on Suzuki
Scan Tool. For further details, refer to operator's manual for
Suzuki Scan Tool.
5) After completing the clearance, turn ignition switch to OFF
position and disconnect Suzuki Scan Tool from DLC.