Table of Contents
Advertisement
1
1
2
"b"
A
Brake Pedal Free Height Check
Peel off carpet and check brake pedal for free height.
If it is not within specification, check and adjust the following
items
.
Brake pedal free height
"a" from silencer (1): 152 – 162 mm (6.0 – 6.4 in.)
• Check brake pedal for dent.
• Check that brake booster is installed securely.
• Check stop light switch position referring to "Brake (Stop)
Light Switch Check" below.
• Check measurement between booster mounting surface and
center of clevis pin hole referring to "Brake Booster Inspec-
tion (for LH Model)" or "Brake Booster Inspection and Adjust-
ment (for RH Model)" in Section 5A.
Brake (Stop) Light Switch Check
1) Check that stop light lights when brake pedal is depressed
the specified distance.
If the measured value is below the specified value, pull
switch slider (2) of brake light switch (1) in the direction of
arrow (A) in the figure to measure the distance again.
Though the measured value is below or above the specified
value, check the following and replace if found defective.
Distance "b": 3.5 – 14 mm (0.14 – 0.55 in.)
a) Check brake light switch referring to "Brake Light Switch
Inspection" in Section 8A.
b) Check brake pedal for dent.
c) Check brake booster for installation.
d) Check brake booster distance between booster installation
surface and the center of clevis pin hole to standard value
referring to "Brake Booster Inspection (for LH Model)" or
"Brake Booster Inspection and Adjustment (for RH Model)"
in Section 5A.
2) Check that stop light is turned off when brake pedal
released.
BRAKES 5-9
Advertisement
Table of Contents
